Reverse Osmosis System 5-Stage & TFC-50 GPD Membrane

Description:
• Five-Stage Reverse Osmosis System & TFC-50 Membrane 
• Made for waters with higher concentrations of chlorine
• Ships Complete with all filters and membrane factory pre-installed 
• For use with all SS series filters and membranes

Added Information:
This reverse osmosis system utilizes five seperate stages to treat your water down to ultimate purity. Using only the finest materials and craftsmanship, your SS Series Reverse Osmosis System will provide your family with great-tasting purified water at your sink, or even at your refridgerator's icemaker. The system is a great alternative to bottled water or to bulky coolers, using heavy to lift bottles, and it's economical too - costing less than a few pennies per gallon!

Uses:
• Great for drinking & cooking too!
• Make great-tasting coffee and tea 
• Connect your system to your icemaker for pure, crystal clear ice cubes
• Use for steam irons, fresh flowers, humidifiers

Stage Description:
• 1: Pre filter - 5 Micron Spun Polypropylene (sediment reduction) 
• 2: Post Filter - 0.5 Micron Carbon Block (taste, odor, and chlorine reduction)
• 3: Additional Post Filter - 0.5 Micron Carbon Block (taste, odor, and chlorine reduction)
• 4: Filmtec NSF TFC-50 Membrane - Thin Film Cellulose (removes impurities) 
• 5: Polishing Filter - Inline Granular Activated Carbon (taste and odor reduction)

Included Accessories:
• Complete 5-Stage Reverse Osmosis System -all filters and membrane factory pre-installed
• Storage tank & Shut-Off Valve - 3.2 Gallon Capacity 
• Chrome Long-Reach Faucet and 3/8" Tubing Adaptor
• Self-Piercing Inlet Saddle Valve Assembly
• Drain Saddle Clamp Assembly 
• System Shut-Off Valve (will automatically shut down system when tank is full)
• Complete Installation Guide

Recommended Operating Conditions:
• Inlet Pressure:   25 PSI - 70 PSI
• Inlet TDS:   0 PPM - 1000 PPM
• Water Temperature:   34°F - 85°F
• Hardness:   < 10 GPG
• Iron:   < 1 PPM
• Filter Change:   9-12 Months 
• Membrane Change:   2-5 Years as Needed
• Polishing Filter Change:   12-18 Months

NOTE: Water conditions outside of the above specified limits may lead to a shortened filter and membrane life.
WARNING: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the unit
CAUTION: System must be protected from freezing. Failure to do so may result in cracking of the filter housing and/or water leakage
NOTE: The membrane element is treated with a chemical preservative. After installation, the system should be flushed with sufficient water  before use.

Shipping Weight: Approx. 25 lbs.